When you are interested in buying a boat, boat shows are one of the best ways to try on many different boats, meet dealers and manufacturers and mingle with the boating community. Even if you aren't in the market, boat shows can be a great way to stay connected to the boating community and the hobby that you love. Then, you can now decide which ever boat you need.
What if you decide to buy a new boat with 70 HP and 15’ Boston whaler Johnson Evinrude motor and try to drive it on the water. The boat was in perfectly trim at about 80% throttle. But when you try to open up the throttle, the boat began bouncing back and forth, rolling from one sponson to the other. That engine has no hydraulic tilt and trim unit and just five holes where you could place a pin to adjust the trim of the engine.
So, would you like your boat motor tilt up and completely experience the best performance now?
Try our best CMC hydraulic Tilt Trim Unit and find solution for some of boat problems encountered.
By installing a tilt trim on your boat, you'll be satisfied to have:
By installing a tilt trim on your boat, you'll be satisfied to have:
· Tilt trim
· Better boat handling
· More speed
· Lower fuel consumption
· NO MORE BACK STRAIN!
Tilt and trim can be used for small and medium size outboards. Also power tilts and trims for large outboard and stern drive boats. It can be easily adjustable from top to bottom. Using this unit the boater can then move the engine up and down as well as tilting it in and out with the power tilt and trim.
We recommend you to mount this PT-130 tilt trim unit to any of 130 HP and smaller outboard motors. It will provide 6” setback which enhances boat stability and enables the prop to get a better “bite” at a higher prop setting. Your transom boat motor will obtain 20 degrees and a total of 90 degrees tilt and trim. Its hydraulic actuator is rated at 7853 lbs of thrust! Also available PT-130 with gauge.
We recommend you to mount this PT-130 tilt trim unit to any of 130 HP and smaller outboard motors. It will provide 6” setback which enhances boat stability and enables the prop to get a better “bite” at a higher prop setting. Your transom boat motor will obtain 20 degrees and a total of 90 degrees tilt and trim. Its hydraulic actuator is rated at 7853 lbs of thrust! Also available PT-130 with gauge.
 |
Another one is the PT-35 tilt trim unit that will fit 35 HP and smaller outboard motors. The motor will have 5 ½ inches of setback from the boat transom to achieve its full potential. Your boat transom will obtain 84 degrees of trim and tilt.
 |
Start checking this link for Tilt Trim products and get the most affordable cost ever! http://magemarinestore.com/cmchytitrun.html
No comments:
Post a Comment