Coil kit sensor is one of the parts you can find in OMC/Johnson Evinrude outboard motors. Buying your coil kit is an essential tool to your boat motor. Without it, the motor will not work. Before taking an action you need to find the correct motor application and understand simple troubleshooting.
If you will buy a new coil kit for OMC/Johnson Evinrude timer base, like part number 133-0875K 1. This kit must contain one replacement sensor, one sensor gap tool and two mounting screws. You need to replace this OMC Johnson Evinrude coil kit with part numbers 133-0875K 1, 580875, 581508, 581585, 763804 385454. This suits 1971-1978 2 Cylinder OMC boat motor timer base.
If some trouble occurs after finding out and installed the correct coil kit. Try checking the resistance between the two sensors wire, you should read between 16 and 19 ohms. The DVA output should be read over 1 volt between the two wires while the wires are connected to the power pack. While the wires are connected to the power pack check your DVA readings from each sensor wire to engine ground. The sensor readings should be close to what is read on the stator.
Besides this simple troubleshooting and information about the coil kit, find out cheaper price and new brand here: http://www.magemarinestore.com/omcig13.html. You can also dial 702-582-9667 or email sales@magemarinestore.com for assistance.
Besides this simple troubleshooting and information about the coil kit, find out cheaper price and new brand here: http://www.magemarinestore.com/omcig13.html. You can also dial 702-582-9667 or email sales@magemarinestore.com for assistance.
 |
No comments:
Post a Comment